DEPCA Switch Settings
    
    +----------------------------------------------------------+
    |W17                                                       |
    | .                    .                                   |
    | .                 W16.                          .        |
    |                                              W15.        |
    |                                              ......      |
    |                                      . . .   ......      |
    |                                      . . .   ......      |
    |                                      W6-8    W9-14       |
    |                         .....                            |
    |                         .....                            |
    |                         .....                            |
    |                         W1-5                             |
    |                                                          |
    +------------------------------------+                     |
                                         |                     |
                                         +---------------------+
                                         

      Jumper    Default         Function

        W1      Top             IRQ2
        W2      Bottom          IRQ3
        W3      Removed         IRQ4
        W4      Removed         IRQ5
        W5      Removed         IRQ7


            Note: Only two jumpers can be install at any time.
                  One in the top position and one in the bottom.
                  The top selects the IRQ for the mouse
                  controller and the bottom for the Network
                  controller.
    
        W6      Installed       I/O Address Select (300-30F)
                                         Removed = (200-20F)


        W7      Installed       Memory Address Select
        W8      Installed       Buffer Size Select

            W7   W8    Mode         Memory Starting Address
            IN   IN    64 Kbyte     D0000 (Primary)
            OUT  IN    64 Kbyte     E0000 (Secondary)
            IN   OUT   32 Kbyte     D8000 (Primary)
            OUT  OUT   32 Kbyte     C8000 (Secondary)

        W9      Bottom          AUI/Mau Select 
        W10     Bottom          AUI/Mau Select
        W11     Bottom          AUI/Mau Select
        W12     Bottom          AUI/Mau Select
        W13     Bottom          AUI/Mau Select
        W14     Bottom          AUI/Mau Select

            Note: Place W9-14 Bottom position for Thinwire and
                  top for Ethernet AUI.

        W15     Installed       Installed for IEEE 802.3 Compliance

            Note: Remove W15 if cable has 9 pins.

        W16                     Remote Boot Enable

        W17                     DC/DC Converter Enable

            Note: Remove W17 for Ethernet AUI.