TITLE:        Procedure for Firmware Upgrade using CLI console
                ------------------------------------------------

  PROBLEM:      How do I upgrade my VNswitch module using CLI console?


  SOLUTION:     Downline load upgrade for the module using the local
                console is done using the following procedure.

                Redirect to module

                Go to menu item "5" CLI local console

                At CLI prompt type "config"

                Boot Config>load remote
                Remote Host Address [0.0.0.0}? "your boot server IP address"
                Remote Pathname []? "your path directory to file "
                First Hop Address [xx.xx.xx.xx]?
                TFTP Timeout Value [10]?
                Are you sure you want to reload the gateway? (Yes or [No]): y


                                                                                
                - After that point you will see the following messages on your
                  CLI screen:

                  System Restart  ...


                  Copyright 1995-1996 Digital Equipment Corp.

                  MOS Operator Control

                  [IP Host-Only Mode - Upgrading Operational Image]

                  Network FLASH update proceeding...
                  TFTP transfer complete, status: OK
                  Starting the writing onto flash

                - A few seconds later, you will se the two top LEDs (#  ->)
                  flashing in alternating yellow and green colors (at a rather
                  fast rate). That means flash has been successfully loaded.