Well, I got quite a few answers, all of them veryfying that it
works. A few fellas sent me pieces of their config files,
and by looking at these I was able to make a config file by hand.
And it worked! This is what it requires:
bus tcds1 at tc0 slot 0 vector tcdsintr
controller asc1 at tcds1 slot 0 vector ascintr
controller asc2 at tcds1 slot 1 vector ascintr
My card was in slot 0, I guess thats where the 'tc0' comes from.
Some people already had a 2nd scsicontroller that of course changes
the tcds & asc numbering.
I still don't know why genvmunix didn't recognize the board,
(I doublechecked that I had the right genvmunix etc). But
this works ok for me.
Thanx to all who replied:
"Dr. Tom Blinn, 603-881-0646" <tpb_at_zk3.dec.com>
Jari Tavi <jpt_at_rixrax.enet.dec.com>
Stan Huhman#HuhmanJohn Deere EW <huhman_at_ee.deere.com>
Kent Adams <Kent.Adams_at_jcu.edu.au>
Lee Askew <Lee.Askew_at_jcu.edu.au>
beb_at_rosat.mpe-garching.mpg.de
morten.hanshaugen_at_usit.uio.no
--harald
Harald Lundberg <hl_at_tekla.fi>;Tekla Oy,Koronakatu 1,FIN-02210,ESPOO,FINLAND
tel +358-{0-8879449work,0-8039489fax,0-8026752,11-728013res,50-5578303mob)
Received on Wed Feb 08 1995 - 11:43:40 NZDT