Hi all,
my original question was about setting-up VPI/VCI communication
on DU 3.2.
The right configuration parameters follows:
> 2) Has someone any experience with configuring ATM network card on DU to
> allow connectivity via VPI/VCI ??
>
> Yes. We have some Intel Paragons with OC-12 ATM boards in them. Here
> are some sample pvc setups from atm.conf on DU 4.0:
>
> This node doesn't support InARP.
>
> # PVC to roguea (134.167.5.22)
> +pvc driver=lta0 converge=atmip vpi=0 vci=162
> run /usr/sbin/atmarp -s PVC 134.167.5.17 permanent
> run /usr/sbin/atmarp -v +vc 0 162 134.167.5.17
>
> This node supports InARP:
>
> # PVC to gumpa (134.167.5.11)
>+pvc driver=lta0 converge=atmip vpi=0 vci=180
Thanks again for help!
Best regards,
Lubos
--------------------------------------------------------------------------
Lubos Kejzlar
System and Network Specialist
Laboratory for Computer Science Tel.: +42-19 2171210
University of West Bohemia +42-19 7221530
Americka 42, 30614 Pilsen Fax: +42-19 2171485
Czech Republic E-mail: kejzlar_at_zcu.cz
--------------------------------------------------------------------------
Received on Wed Sep 11 1996 - 19:44:39 NZST