I have a problem on a DS10L while attempting to boot the Tru64 5.1b install CDROM.
If I boot from the hard disk, the CDROM drive works OK when mounted from Tru64.
When I power on the system, the CD drive is reported correctly by 'show dev' at SRM:
dqb0.0.1.13.0 DQB0 CD-224E 9.5B
If I try to boot the GENERIC 5.1b boot-linked kernel from CDROM, I get an error "kernel stack not valid halt":
>>>boot dqb0 -fl a -fi GENERIC
(boot dqb0.0.1.13.0 -file GENERIC -flags a)
block 0 of dqb0.0.1.13.0 is a valid boot block
reading 15 blocks from dqb0.0.1.13.0
bootstrap code read in
base = 2c0000, image_start = 0, image_bytes = 1e00(7680)
initializing HWRPB at 2000
initializing page table at 1ffee000
initializing machine state
setting affinity to the primary CPU
jumping to bootstrap code
UNIX boot - Wednesday October 16, 2002
Loading GENERIC ...
Loading at fffffc0000310000
Linking 205 objects: 205
halted CPU 0
halt code = 2
kernel stack not valid halt
PC = 0
Now if I do 'show dev' again, I get a weird corruption of the device name:
dqb0.0.1.13.0 DQB0 CD/224G " " " " " " " " ;.7B" "
If I do an 'init' after the problem has occurred, I get a subsequent self-test failure:
Testing the Disks (read only)
*** Hard Error - Error #8 -
Diagnostic Name ID Device Pass Test Hard/Soft 1-JAN-2000
exer_kid 00000317 dqb0.0.1.13.0 0 0 1 0 12:00:01
Buffer counts differ - buf1:0, buf2:512, location:2a00
*** End of Error ***
I thought maybe this was a problem with the CDROM drive, so I changed it for a drive on another system that works OK, but the problem still remains. I've also tried changing the drive ribbon cable but that didn't help either.
The only way to get back to a 'valid' device name is to cycle the power supply.
Any ideas? I'm wondering if this is a fault on the motherboard.
thanks,
Iain
Received on Mon Mar 01 2004 - 19:24:14 NZDT