Dear managers,
I fased problem on MSL6000 tape library Withe two DLT
tape drive,
after connect the A.C power to it it continue boot
after finish the self test it displays the following
message on its display,
"one or more drive are not installed"
note the devices on:
(SCSI BUSS0) is:
"there are no devices attatched to this bus at this
time"
(SCSI BUSS1) is:
protocol bus device type state target Id
LunID
SCSI 1 CHGR up 0 0
SCSI 1 TAPE up 1 0
I check SCSI cables its ok,
I replaced between tow drives the broblem as it,
one or more drive not installed,
I return the configuration to factory and reconfig it
the problem is same,
please advise,
mahmod.
__________________________________
Do you Yahoo!?
Yahoo! Mail - Helps protect you from nasty viruses.
http://promotions.yahoo.com/new_mail
Received on Thu Jun 17 2004 - 07:35:25 NZST