skip book previous and next navigation links
go up to top of book: HP Open Source Security for OpenVMS Volume 3:... HP Open Source Security for OpenVMS Volume 3:...
go to beginning of chapter: Installation and Configuration Installation and Configuration
go to previous page: Installing and Configuring Kerberos on OpenVMS Alpha Version 7.3-2 Installing and Configuring Kerberos on OpenVMS Alpha Version...
go to next page: Configuring HP TCP/IP Services for OpenVMS Telnet with KerberosConfiguring HP TCP/IP Services for OpenVMS Telnet with Kerberos
end of book navigation links

Installing and Configuring Kerberos on OpenVMS VAX Version 7.3 



If you previously installed Kerberos for VAX Version 1.0 on OpenVMS 7.3, perform the following steps to upgrade Kerberos.

  1. Download the Kerberos kit from the Kerberos for OpenVMS website at

    http://h71000.www7.hp.com/openvms/products/kerberos/

  2. Expand the Kerberos kit by entering the following command:

    $ RUN HP-VAXVMS-KERBEROS-xxxx.PCSI_DCX_VAXEXE

  3. Shut down Kerberos by executing SYS$STARTUP:KRB$SHUTDOWN.COM.

  4. Remove Kerberos by entering the PRODUCT REMOVE KERBEROS command.

  5. Install the Kerberos Version kit by entering PRODUCT INSTALL KERBEROS.

  6. Add @SYS$STARTUP:KRB$SYMBOLS to SYS$MANAGER:SYLOGIN.COM, if Kerberos was not previously installed and configured.

  7. Execute KRB$CONFIGURE.COM, if Kerberos was not previously installed and configured.

  8. Start Kerberos by executing SYS$STARTUP:KRB$STARTUP.COM.

See Example 2-1 for a sample Kerberos configuration log. The configuration log is the same on OpenVMS I64, OpenVMS Alpha, and OpenVMS VAX.

go to previous page: Installing and Configuring Kerberos on OpenVMS Alpha Version 7.3-2 Installing and Configuring Kerberos on OpenVMS Alpha Version...
go to next page: Configuring HP TCP/IP Services for OpenVMS Telnet with KerberosConfiguring HP TCP/IP Services for OpenVMS Telnet with Kerberos