Online Sun Information ArcHive
|
|
501-2031
4/30 (SPARCstation LX/ZX) motherboard 32M
50 MHz microSPARC. 20MHz SBus.
This board is an unusual shape. On one edge are edge connectors. All
directions below are given assuming the component side up and the edge
connectors toward you.
There are two jumpers.
J1801 (3-pin jumper in near right corner)
1-2 100-ohm ISDN TE termination enabled JUMPED
2-3 disabled
J1802 (3-pin jumper in near right corner)
1-2 100-ohm ISDN TE termination enabled JUMPED
2-3 disabled
The onboard video produces analog color output at the following resolution and
sync frequencies: 1152 x 900 @ 61.8KHz horizontal, 66Hz vertical; 1152 x 900
@ 71.7KHz horizontal, 76Hz vertical; 1024 x 768 @ 61.8KHz horizontal, 77Hz
vertical; and 1600 x 1280 @ 71.7KHz horizontal, 76Hz vertical. Onboard VRAM
is 1M; a 501-2061 1M VSIMM may be installed in U1301 (on right) to achieve 2M
VRAM.
Memory consists of up to six SIMMs, in three pairs of 4M (501-1991) or 16M
(501-2059) SIMMs. SIMM types may be mixed, and should be installed according
to this table:
bank1 bank2 bank3 bank1 bank2 bank3
total RAM U0304 U0301 U0402 U0303 U0302 U0401
--------- ----- ----- ----- ----- ----- -----
16M 4M 4M 4M 4M
24M 4M 4M 4M 4M 4M 4M
32M 16M 16M
40M * 4M 16M 4M 16M
48M * 4M 4M 16M 4M 4M 16M
or 16M 4M 4M 16M 4M 4M
64M 16M 16M 16M 16M
72M * 4M 16M 16M 4M 16M 16M
96M 16M 16M 16M 16M 16M 16M
Rows marked with '*' do not work under SunOS 4.1.3c. "Put 16MB SIMMs in Bank
1."
Additional features of interest: the boot PROM is a PLCC in the near left
corner, at location U0701. The NVRAM is beyond the boot PROM at location
U0707. Ethernet fuse F2001 and SCSI TERMPWR fuse F0601 are in the near left
corner. Keyboard fuse F2001 and audio fuse F2003 are in the middle near
edge. Along the far edge, more or less from left to right, are the
speaker/LED, power, floppy, and internal SCSI connectors.
Note that the SPARCstation LX/ZX was first supported in SunOS 4.1.3c.
Note that when the 501-2061 VSIMM is installed, (one of?) the following
commands should be issued at the ROM monitor prompt:
setenv output-device screen:r1280x1024x67
setenv output-device screen:r1280x1024x76
setenv output-device screen:r1600x1280x76
Note that when the '16" Mid-Range Color Monitor' is installed, (one of?) the
following commands should be issued at the ROM monitor prompt:
setenv output-device screen:r1152x900x66
setenv output-device screen:r1024x768x77
[ home ]
[ hardware ]
[ software ]
[ more... ]
[ search ]
[ layout ]
Last modified: 2000.12.07.22.26.13 CST
Server time: 2008.12.06.05.31.12 GMT